Effect of Carbon Nanotube Reinforcement on the Hot Corrosion Resistance of Zirconium-Yttrium Coatings in Molten Salt

Authors

  • Neeluri Suresh, Suraj Bhan Author

DOI:

https://doi.org/10.48047/6w2s5a28

Keywords:

Hot corrosion · Porosity · Plasma spray · CNT · T-91 steel

Abstract

The present study examines the hot corrosion behavior of carbon nanotube (CNT)reinforced zirconium-yttrium coatings on T-91 boiler tube steel in a molten salt environment consisting of Na₂SO₄–60 wt% V₂O₅ at 600 °C under cyclic conditions. The coatings were 
fabricated using the air plasma spray technique. Uncoated and coated specimens, along with all as-coated samples, were exposed to hot corrosion in a silicon tube furnace at 600 °C for 50 cycles. Corrosion behavior was assessed by measuring the mass gain after each cycle. The corroded products were characterized using X-ray diffraction (XRD), scanning electron microscopy (SEM), and energy dispersive X-ray analysis (EDAX). 

Downloads

Download data is not yet available.

References

Duarte CA, Espejo E, Martinez JC (2017) Failure analysis of the wall tubes of a water-tube Eng Fail Anal ://doi.org/10.1016/j.engfa ilana l.2017.05.032

Alia FF et al (2017) High temperature oxidation in boiler environment of chromized steel. IOP Conf Ser. https ://doi.org/10.1088/1757-899X/257/1/01208 6.

Kumar D, Pandey KN, Das DK (2016) Microstructure studies of air-plasma-spraydeposited CoNiCrAlY coatings before and after thermal cyclic loading for hightemperature application. Int J Miner Metall Mater 23(8):934–942. https ://doi.org/10.1007/s12613-016-1309-x

Downloads

Published

2024-11-20

How to Cite

Effect of Carbon Nanotube Reinforcement on the Hot Corrosion Resistance of Zirconium-Yttrium Coatings in Molten Salt (Neeluri Suresh, Suraj Bhan , Trans.). (2024). Cuestiones De Fisioterapia, 53(03), 2541-2552. https://doi.org/10.48047/6w2s5a28